
Bottom Bracket ๐
So… how do we fill that hole so it fits the crank axle? Again, I’m all new into this do-it-yourself bike building stuff. After researching the internet I found out that I most likely needed a BB86. At least, that’s what the VeloBuild website says. It looks the Shimano DURA-ACE Press Fit Bottom Bracket 86.5 mm shell width (SM-BB92-41B) would suit the bottom bracket. I must admit, this is all very confusing to me as their product code says BB92 but the specs say 86.5.
Coming up next: Looking for a Press-Fit Bottom Bracket Tool. ๐ฉ


The links below gives you a bit of an explanation on the subject:
>> https://www.mantel.com/blog/en/bottom-bracket-shells-and-bottom-brackets
>> https://www.bikeradar.com/advice/buyers-guides/the-complete-guide-to-bottom-bracket-standards/
klopt. Shimano Dura Ace BB92 heb ik er bij mij ook inzitten en dat werkt perfect.
En ivm die tool kan ik een DIY build aanraden. Ik ga er niet vanuit dat je wekelijks een bottom bracket moet installeren en de tools zijn dus best prijzig.
Ikzelf ben toen ook gaan zoeken en het net staat vol DIY tools. Eventjes naar de lokale bouwmarkt een draadstang halen, wat bouten en rondellen en dat werkte perfect voor een paar euro.
Een voorbeeld:
https://www.youtube.com/watch?v=4CckuwvipcM&feature=emb_logo
Thanks voor de tip!
Ik heb onlangs zelf een tool in elkaar gezet en die werkte prima.
M20 draadeind (gamma)
Een paar carrosserie ringen (Toolstation)
2 50mm Sluitplaten (Toolstation)
Totaal rond de 6 euro denk ik en werkte perfect.